Compressed class B stranded annealed uncoated copper.
Conductor Shield:
Extruded semi-conducting co-polymer compound.
Insulation:
105°C rated Ethylene Propylen Rubber (EPR) per ICEA S-93-639 section 4 and UL-1072.
Insulation Shield:
Extruded semi-conducting co-polymer compound applied directly over the insulation. The conductor shield, insulation and insulation shield are applied in one tandem operation.
Shield:
Uncoated helically applied 5 mil bare copper tape with a nominal overlap of 25%.
Jacket:
Extruded PVC jacket with excellen mechanical properties.
Jacket is UL recognized as being "sunlight resistant."
Application:
UL listed and OSHA acceptable. Where NEC requirements apply, cables are suitable for use in wet or dry locations at maximum operating temperature of 105°C for normal operation; 140°C for emergency overload conditions; and 250°C for short circuit conditions. Cables may be installed in conduit, duct or aerially when properly supported by a messenger. Cables are also suitable for direct burial if installed in a system with a grounding conductor that is in close proximity and conforms with Article 250.4(A)(5) and 250.4(B)(4) of the 2002 NEC.
Approval:
Conforms to AEIC CS6 for ethylene propylene rubber insulated shielded power cables.
Conforms to ICEA pub. no. S-68-516, NEMA pub. no. WC8 for ethylene propylene-rubber- insulated wire and cable.
Listed by UL as Type MV-105, per Standard 1072. 105°C Wet or Dry locations.
Listed by UL as sunlight resistant.
Sizes 1/0 and larger UL listed for CT use.
Conforms to federal specification J-C-30B.
Attribute
Value
Item #
25101
Item Name
25101, EPR-PVC (15000V Shielded, Grounded) Type MV105 Power Cable – 100% Insulation Level
